Laser cutting Machine in Kitchen utensils Industry
Compared with the traditional plate cutting method, the laser cutting machine has obvious advantages. It has the advantages of fast cutting speed and high production efficiency, good cutting quality and narrow cutting seam. Metal laser cutting machine can be well adapted to materials, no tool wear. Whether it is simple or complex parts, you can use laser precision rapid prototyping cutting. High degree of automation, simple operation, low labor intensity, no pollution. The production cost is low and the economic benefit is good. The effective life cycle of the metal laser cutting technology is long.
Compared with other metal cutting machines, fiber laser cutting machine also has obvious advantages. In heat cutting, neither oxygen cutting nor plasma cutting can concentrate energy in a very small area like a laser beam. Excessive range of heat effect leads to wide notch and obvious deformation of workpiece. The oxygen cutting machine has the advantages of small equipment and less investment cost, and is a flexible cutting tool, but because of its large heat affected area and it’s cutting speed is low, resulting in a severe saw-tooth and a wave-like shape of the incision. Plasma cutting is similar to laser cutting speed, which is obviously higher than flame cutting, but the cutting energy of the cutting edge is low, the top of the trimming is in the shape of a round head. In operation, it is also necessary to prevent the damage caused by ultraviolet radiation from the arc to the operator. In the mechanical stamping process, the die stamping method is used to produce a large number of parts, which has the advantages of low cost and short production cycle. However, this method is difficult to adapt to the design changes, the equipment is special, the manufacturing cycle is long, and the cost is high.
For small and medium-sized enterprises, the advantages of optical fiber laser cutting machine are fully demonstrated. Fiber laser cutting machine is convenient for the tight arrangement of the workpiece, and saves the material more than the die blanking which needs to reserve more material margin around each workpiece. For large and complex parts that need to be cut in segments, they need to be punched, resulting in many small shell-like edges on the edge, resulting in a large amount of edge and corner residual materials and its cutting speed is much slower than that of fiber laser cutting. Moreover, as a flexible contactless cutting tool, laser can cut in any direction from any point of the material. The method of electric discharge or wire cutting is used for fine processing of hard material, although the cut is flat, the cutting speed is much slower than the laser cutting. Although water cutting can cut many non-metallic materials, the operation cost is high.
Therefore, in the kitchen production industry, with the various shapes of kitchen tools, the choice of metal fiber laser cutting machine is undoubtedly the best choice.